+.It Va UDPDiscovery Li = yes | no Po yes Pc
+When this option is enabled tinc will try to establish UDP connectivity to nodes,
+using TCP while it determines if a node is reachable over UDP. If it is disabled,
+tinc always assumes a node is reachable over UDP.
+Note that tinc will never use UDP with nodes that have
+.Va TCPOnly
+enabled.
+.It Va UDPDiscoveryKeepaliveInterval Li = Ar seconds Pq 9
+The minimum amount of time between sending UDP ping datagrams to check UDP connectivity once it has been established.
+Note that these pings are large, since they are used to verify link MTU as well.
+.It Va UDPDiscoveryInterval Li = Ar seconds Pq 2
+The minimum amount of time between sending UDP ping datagrams to try to establish UDP connectivity.
+.It Va UDPDiscoveryTimeout Li = Ar seconds Pq 30
+If tinc doesn't receive any UDP ping replies over the specified interval,
+it will assume UDP communication is broken and will fall back to TCP.
+.It Va UDPInfoInterval Li = Ar seconds Pq 5
+The minimum amount of time between sending periodic updates about UDP addresses, which are mostly useful for UDP hole punching.
+.It Va UDPRcvBuf Li = Ar bytes Pq 1048576
+Sets the socket receive buffer size for the UDP socket, in bytes.
+If set to zero, the default buffer size will be used by the operating system.
+Note: this setting can have a significant impact on performance, especially raw throughput.
+.It Va UDPSndBuf Li = Ar bytes Pq 1048576
+Sets the socket send buffer size for the UDP socket, in bytes.
+If set to zero, the default buffer size will be used by the operating system.
+Note: this setting can have a significant impact on performance, especially raw throughput.