-.Dd 2016-02-27
+.Dd 2016-10-29
.Dt TINC.CONF 5
.\" Manual page created by:
.\" Ivo Timmermans
to start with a four byte header containing the address family,
followed by an IP header.
This mode should support both IPv4 and IPv6 packets.
+.It utun Pq OS X
+Set type to utun.
+This is only supported on OS X version 10.6.8 and higher, but doesn't require the tuntaposx module.
+This mode should support both IPv4 and IPv6 packets.
.It tap Pq BSD and Linux
Set type to tap.
Tinc will expect packets read from the virtual network device
.Va Address
variables can be specified, in which case each address will be tried until a working
connection has been established.
-.It Va Cipher Li = Ar cipher Pq blowfish
+.It Va Cipher Li = Ar cipher Pq aes-256-cbc
The symmetric cipher algorithm used to encrypt UDP packets.
-Any cipher supported by OpenSSL is recognised.
+Any cipher supported by LibreSSL or OpenSSL is recognised.
Furthermore, specifying
.Qq none
will turn off packet encryption.
This option sets the level of compression used for UDP packets.
Possible values are 0 (off), 1 (fast zlib) and any integer up to 9 (best zlib),
10 (fast lzo) and 11 (best lzo).
-.It Va Digest Li = Ar digest Pq sha1
+.It Va Digest Li = Ar digest Pq sha256
The digest algorithm used to authenticate UDP packets.
-Any digest supported by OpenSSL is recognised.
+Any digest supported by LibreSSL or OpenSSL is recognised.
Furthermore, specifying
.Qq none
will turn off packet authentication.
.El
.Sh SEE ALSO
.Xr tincd 8 ,
-.Pa http://www.tinc-vpn.org/ ,
+.Pa https://www.tinc-vpn.org/ ,
.Pa http://www.tldp.org/LDP/nag2/ .
.Pp
The full documentation for