.Ev REMOTEPORT
are available.
.El
-.It Va ReplayWindow Li = Ar bytes Pq 16
+.It Va ReplayWindow Li = Ar bytes Pq 32
This is the size of the replay tracking window for each remote node, in bytes.
The window is a bitfield which tracks 1 packet per bit, so for example
-the default setting of 16 will track up to 128 packets in the window. In high
+the default setting of 32 will track up to 256 packets in the window. In high
bandwidth scenarios, setting this to a higher value can reduce packet loss from
the interaction of replay tracking with underlying real packet loss and/or
reordering. Setting this to zero will disable replay tracking completely and
Note that tinc will never use UDP with nodes that have
.Va TCPOnly
enabled.
-.It Va UDPDiscoveryInterval Li = Ar seconds Pq 9
-The minimum amount of time between sending UDP ping datagrams to test UDP connectivity.
+.It Va UDPDiscoveryKeepaliveInterval Li = Ar seconds Pq 9
+The minimum amount of time between sending UDP ping datagrams to check UDP connectivity once it has been established.
+Note that these pings are large, since they are used to verify link MTU as well.
+.It Va UDPDiscoveryInterval Li = Ar seconds Pq 2
+The minimum amount of time between sending UDP ping datagrams to try to establish UDP connectivity.
.It Va UDPDiscoveryTimeout Li = Ar seconds Pq 30
If tinc doesn't receive any UDP ping replies over the specified interval,
it will assume UDP communication is broken and will fall back to TCP.
-.It Va UDPRcvBuf Li = Ar bytes Pq OS default
+.It Va UDPRcvBuf Li = Ar bytes Pq 1048576
Sets the socket receive buffer size for the UDP socket, in bytes.
-If unset, the default buffer size will be used by the operating system.
-.It Va UDPSndBuf Li = Ar bytes Pq OS default
+If set to zero, the default buffer size will be used by the operating system.
+Note: this setting can have a significant impact on performance, especially raw throughput.
+.It Va UDPSndBuf Li = Ar bytes Pq 1048576
Sets the socket send buffer size for the UDP socket, in bytes.
-If unset, the default buffer size will be used by the operating system.
+If set to zero, the default buffer size will be used by the operating system.
+Note: this setting can have a significant impact on performance, especially raw throughput.
.El
.Sh HOST CONFIGURATION FILES
The host configuration files contain all information needed