VPN between two servers
Torsten Schlabach
tschlabach at gmx.net
Fri Apr 21 13:57:20 CEST 2006
> Have you enabled IP forwarding on both machines?
This was the problem! Thank you for the hint.
Actually,
echo 1 > /proc/sys/net/ipv4/ip_forward
made the difference.
Regards,
Torsten
Brian Candler schrieb:
> On Fri, Apr 21, 2006 at 11:16:22AM +0200, Torsten Schlabach wrote:
>
>>I would like to use tinc to create a virtual private network that just
>>exists between the two servers. I want a virtual interface on each of the
>>servers, probably with a 192.168.x.x address so that I could have some
>>daemon on server A listen to say 192.168.1.1 only and have server B connect
>>to that daemon through the tinc VPN from 192.168.1.2 for example.
>>
>>I think all the samples work from the assumption that the servers are
>>gatways that have networks behind them. I have setup my boxes according to
>>the samples, but I cannot ping between the virtual interfaces.
>
>
> Did you configure 192.168.1.1 and 192.168.1.2 as loopback addresses on the
> two machines? (e.g. ifconfig lo:0 192.168.1.1/32)
>
> Have you chosen the right source address when pinging? e.g.
>
> ping -S 192.168.1.1 192.168.1.2
>
> Have you enabled IP forwarding on both machines?
>
> What does tcpdump show when you do the ping command shown above?
>
> Just a few suggestions from someone who lurks on the TINC list rather than
> actually uses it :-) Another option you could consider is to configure IPSEC
> transport mode between the two machines, but that's not TINC.
>
> Regards,
>
> Brian.
> _______________________________________________
> tinc mailing list
> tinc at tinc-vpn.org
> http://brouwer.uvt.nl/cgi-bin/mailman/listinfo/tinc
>
More information about the tinc
mailing list