Can I pass 802.1q (VLAN tagged) through a VPN Tinc inHUB/Switchmode?.

[michael-dev at fami-braun.de]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Hi,

Ramses II schrieb:
> But you don't are working with the wrt54gl router, isn't it?

you're right, but question was about bridging and tagging.

>
> Can you be most explicit with your config?.

wlan0:
> brctl show
  br0: eth2 tinc
> vconfig:
  vlan82: br0
> ip addr
  vlan82 1.2.3.4/24

With eth2 being a interface that has some a couple of tagged vlans
attached to it on switchport side.

ap1:
> brctl show
  br0: wlan0 vlan82
  br84: wlan0_1.84 vlan84
> vconfig:
  vlan82: tinc
  vlan84: tinc
> ip addr
  br0 1.2.3.5/24

With wlan0 and wlan0_1.84 begin interfaces which receive data from the
wireless card driver.

As both communication in vlan 84 via ap1 and wlan0 works as well as
communication in vlan 82 via ap1 to wlan0 as well as communication
in vlan82 between the aps work, I guess that quite complete.

Regards,
 M. Braun
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.9 (GNU/Linux)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org

iEYEARECAAYFAkuoALkACgkQja4h02Y9mlcdwwCdFeT79/Nm+KAxFoJdOTckw1ck
JCMAnjZwttJtry9VVd3lrf0eJucQg+RZ
=f4xE
-----END PGP SIGNATURE-----