Configuration advice on a single interface server

[Terry T]

Is it possible to configure a bridge mode VPN with only a single physical
interface eth0. The scenario is that the proposed tinc server is assigned a
static 10.10.145.254/24 that is connected to a Cisco router. Incoming
traffic can be set up to be forwarded to this server.

Remote tinc client has a need to receive multicast hence the server must be
configured in bridge mode. However, I can't get my head around configuring
the bridge for the server, and the setup for the client.

Any advice will be appreciated.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.tinc-vpn.org/pipermail/tinc/attachments/20150318/e35a3383/attachment.html>