tinc - switch mode bridge

[Yazeed Fataar]

Any input?

Regards
Yazeed Fataar
<yazeedfataar at hotmail.com>

On Tue, Apr 5, 2016 at 11:26 AM, Yazeed Fataar <yazeedfataar at gmail.com>
wrote:

> Hi
>
> I am testing running tinc in switch mode. , my topology is as follows
>
> Site 1 (tinc-srv01) -> Site 2 (tinc-srv02)
>
> I have configured the bridge interfaces with ip addresses and able to ping
> between bridges. I then setup a server on each site and tested layer 2
> connectivity between the two servers. Topology as follows.
>
> Server 1 - *Site 1* (tinc-srv01) -> *Site 2* (tinc-srv02) - Server 2
>
> My ping test are as follows
>
> *Site 1*
> Server -ping- Site 1 (tinc-srv01) - Success
> Server -ping- Site 2 (tinc-srv02) - Success
> Server -ping- Site 2 - Server 2 - Failure
>
> *Site 2*
> Server -ping- Site 2 (tinc-srv02) - Success
> Server -ping- Site 1 (tinc-srv01) - Failure
> Server -ping- Site 1 - Server 1 - Failure
>
> Site 2 tinc-srv02 and server are running in a hosted environment (vmware
> esxi hypervisor) . while Site 1 and tinc-srv01 are running on my laptop
> (vmware workstation). On the server in site 2 it appears that there is no
> arp entries being propagated in its arp table. Is there a feature I need to
> enable ( ie Proxy Arp) on tinc-srv02 the arp to reach the server (site 2) ?
>
> My tinc-srv02 in Site 2 has one interface that I have bridged with tun0.
>
> Please advise?
>
>
>
> <yazeedfataar at hotmail.com>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.tinc-vpn.org/pipermail/tinc/attachments/20160410/2cc6a014/attachment.html>