Bridge not forwarding multicast traffic to the tap interface
Liang Guo
bluestonechina at gmail.com
Sat May 14 08:54:27 CEST 2016
> tap0 Link encap:Ethernet HWaddr ae:a2:e1:cd:aa:68
> inet6 addr: fe80::aca2:e1ff:fecd:aa68/64 Scope:Link
> UP BROADCAST RUNNING PROMISC MULTICAST MTU:1500 Metric:1
> RX packets:0 errors:0 dropped:0 overruns:0 frame:0
> TX packets:2336 errors:0 dropped:0 overruns:0 carrier:0
> collisions:0 txqueuelen:500
> RX bytes:0 (0.0 B) TX bytes:1015186 (991.3 KiB)
>
> bridge name bridge id STP enabled interfaces
> br0 8000.7a22d71b042e no eth0
> tap0
>
tap0 RX packets is 0, can you double check your tinc config is correct?
You'd better remove tap0 from br0, configure sufficient ip address on
tap0, then check the connection with other tinc nodes.
--
Liang Guo
http://guoliang.me/
More information about the tinc
mailing list