Do you see the traffic wrapped up in the tunnel using whatever ports you specified tinc to use?<br><br><div class="gmail_quote">On Fri, Sep 25, 2009 at 6:17 PM, Robert Spraggs <span dir="ltr"><<a href="mailto:rspraggs@aegissystems.com">rspraggs@aegissystems.com</a>></span> wrote:<br>
<blockquote class="gmail_quote" style="border-left: 1px solid rgb(204, 204, 204); margin: 0pt 0pt 0pt 0.8ex; padding-left: 1ex;">
<div bgcolor="#ffffff" text="#000000">
I think that I have them connected in switched mode (I had to change
the Address= fields to the Network Bridge addresses) But I am not able
to determine if there is any traffic being captured on the device. I
think that all information is still going out the Local Interface.<br><font color="#888888">
<br>
Robert</font><div><div></div><div class="h5"><br>
<br>
Donald Pearson wrote:
<blockquote type="cite">As you're running these on windows boxes. Why don't you
bridge your tinc interfaces to your physical interfaces, and run tinc
in switch mode?<br>
<br>
<div class="gmail_quote">On Fri, Sep 25, 2009 at 3:54 PM, Robert
Spraggs <span dir="ltr"><<a href="mailto:rspraggs@aegissystems.com" target="_blank">rspraggs@aegissystems.com</a>></span>
wrote:<br>
<blockquote class="gmail_quote" style="border-left: 1px solid rgb(204, 204, 204); margin: 0pt 0pt 0pt 0.8ex; padding-left: 1ex;">
<div bgcolor="#ffffff" text="#000000">
When I do that, the Windows complains about there being 2 interfaces
with the same IP address. I ignore the error warning, start tinc and
nothing happens on either side.<br>
<br>
Robert<br>
<br>
Guus Sliepen wrote:
<blockquote type="cite">
<div>
<pre>On Fri, Sep 25, 2009 at 11:40:11AM -0700, Robert Spraggs wrote:
</pre>
<blockquote type="cite">
<pre>I tried the configuration below and I get the following error on homeClient
Cannot route packet from homeClient (MYSELF): unknown ipv4 destination address 10.10.255.255
I get the following error on vpnoffice
Cannot route packet from vpnoffice (MYSELF): unknown ipv4 destination address 10.5.255.255
</pre>
</blockquote>
<pre>You also need to change the IP address and the netmask of the TAP interfaces,
see my previous email.
</pre>
</div>
<pre><hr width="90%" size="4"><div>
_______________________________________________
tinc mailing list
<a href="mailto:tinc@tinc-vpn.org" target="_blank">tinc@tinc-vpn.org</a>
<a href="http://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc" target="_blank">http://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc</a>
</div></pre>
<div>
<pre><hr width="90%" size="4">
No virus found in this incoming message.
Checked by AVG - <a href="http://www.avg.com" target="_blank">www.avg.com</a>
Version: 8.5.409 / Virus Database: 270.13.112/2394 - Release Date: 09/25/09 05:51:00
</pre>
</div>
</blockquote>
</div>
<br>
_______________________________________________<br>
tinc mailing list<br>
<a href="mailto:tinc@tinc-vpn.org" target="_blank">tinc@tinc-vpn.org</a><br>
<a href="http://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc" target="_blank">http://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc</a><br>
<br>
</blockquote>
</div>
<br>
<pre><hr width="90%" size="4">
_______________________________________________
tinc mailing list
<a href="mailto:tinc@tinc-vpn.org" target="_blank">tinc@tinc-vpn.org</a>
<a href="http://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc" target="_blank">http://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc</a>
</pre>
<pre><hr width="90%" size="4">
No virus found in this incoming message.
Checked by AVG - <a href="http://www.avg.com" target="_blank">www.avg.com</a>
Version: 8.5.409 / Virus Database: 270.13.112/2394 - Release Date: 09/25/09 05:51:00
</pre>
</blockquote>
</div></div></div>
<br>_______________________________________________<br>
tinc mailing list<br>
<a href="mailto:tinc@tinc-vpn.org">tinc@tinc-vpn.org</a><br>
<a href="http://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc" target="_blank">http://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc</a><br>
<br></blockquote></div><br>