[[!meta title="proxy ARP as an alternative to bridging"]]

## Example: proxy ARP as an alternative to bridging

If one wants to have a remote node appear to be on a local LAN (i.e., having an
IP address inside the local LAN's subnet), one can set up a bridge at the local
node, as described in the [[bridging example|examples/bridging]].  However,
setting up a bridge is rather complex, and if one only needs unicast IP traffic
to work, and broadcast or non-IP traffic is not a requirement, one can use the
[proxy ARP](http://en.wikipedia.org/wiki/Proxy_ARP) features of the operating
system instead.

Since we only use unicast IP traffic, proxy ARP works with both router and
switch mode.

### Overview

The network setup is as follows:

* Office LAN, the LAN on interface eth0 uses the range 192.168.1.0/24. The office node uses the address 192.168.1.2.
* Road warrior, using the address 192.168.1.123. 

### Configuration of tinc at the office

	host# cat /etc/tinc/vpn/tinc.conf
	Name = office
	#Optional:
	#Mode = switch
	
	host# cat /etc/tinc/vpn/tinc-up
	#!/bin/sh
	
	ifconfig $INTERFACE 192.168.1.2 netmask 255.255.255.255
	route add 192.168.1.123 dev $INTERFACE
	echo 1 >/proc/sys/net/ipv4/conf/eth0/proxy_arp
	echo 1 >/proc/sys/net/ipv4/conf/$INTERFACE/proxy_arp
	
	host# ls /etc/tinc/vpn/hosts
	office  roadwarrior  ...
	
	host# cat /etc/tinc/vpn/hosts/office
	Address = 123.234.123.42
	Subnet = 192.168.1.0/24
	-----BEGIN RSA PUBLIC KEY-----
	...
	-----END RSA PUBLIC KEY-----
	
	host# cat /etc/tinc/vpn/hosts/roadwarrior
	Subnet = 192.168.1.123
	-----BEGIN RSA PUBLIC KEY-----
	...
	-----END RSA PUBLIC KEY-----

### Configuration of tinc at the road warrior

	host# cat /etc/tinc/vpn/tinc.conf
	Name = roadwarrior
	#Optional:
	#Mode = switch
	
	host# cat /etc/tinc/vpn/tinc-up
	#!/bin/sh
	
	ifconfig $INTERFACE 192.168.1.123 netmask 255.255.255.0

The host config files are, of course, identical to those on the office node.

### Automatically adding routes

In the above configuration, the `tinc-up` script of the office node has a route
to the roadwarrior's address hardcoded.  To have tinc automatically add the
necessary routes, remove the `route add` command from the `tinc-up` script, and
instead add this `subnet-up` script:

	host# cat /etc/tinc/vpn/subnet-up
	#!/bin/sh
	[ "$NAME" = "$NODE" ] && exit 0
	ip route replace $SUBNET dev $INTERFACE