won't try to connect to other daemons at all,
and will instead just listen for incoming connections.
-.It Va DecrementTTL Li = yes | no Po yes Pc
+.It Va DecrementTTL Li = yes | no Po no Pc Bq experimental
When enabled,
.Nm tinc
will decrement the Time To Live field in IPv4 packets, or the Hop Limit field in IPv6 packets,
before forwarding a received packet to the virtual network device or to another node,
and will drop packets that have a TTL value of zero,
in which case it will send an ICMP Time Exceeded packet back.
+.Pp
+Do not use this option if you use switch mode and want to use IPv6.
.It Va Device Li = Ar device Po Pa /dev/tap0 , Pa /dev/net/tun No or other depending on platform Pc
The virtual network device to use.
When combined with the IndirectData option,
packets for nodes for which we do not have a meta connection with are also dropped.
+.It Va ECDSAPrivateKeyFile Li = Ar filename Po Pa @sysconfdir@/tinc/ Ns Ar NETNAME Ns Pa /ecdsa_key.priv Pc
+The file in which the private ECDSA key of this tinc daemon resides.
+This is only used if
+.Va ExperimentalProtocol
+is enabled.
+
+.It Va ExperimentalProtocol Li = yes | no Po no Pc Bq experimental
+When this option is enabled, experimental protocol enhancements will be used.
+Ephemeral ECDH will be used for key exchanges,
+and ECDSA will be used instead of RSA for authentication.
+When enabled, an ECDSA key must have been generated before with
+.Nm tincctl generate-ecdsa-keys .
+The experimental protocol may change at any time,
+and there is no guarantee that tinc will run stable when it is used.
+
.It Va Forwarding Li = off | internal | kernel Po internal Pc Bq experimental
This option selects the way indirect packets are forwarded.
.Bl -tag -width indent
Subnets can either be single MAC, IPv4 or IPv6 addresses,
in which case a subnet consisting of only that single address is assumed,
or they can be a IPv4 or IPv6 network address with a prefixlength.
-Shorthand notations are not supported.
For example, IPv4 subnets must be in a form like 192.168.1.0/24,
where 192.168.1.0 is the network address and 24 is the number of bits set in the netmask.
Note that subnets like 192.168.1.1/24 are invalid!
Read a networking HOWTO/FAQ/guide if you don't understand this.
-IPv6 subnets are notated like fec0:0:0:1:0:0:0:0/64.
+IPv6 subnets are notated like fec0:0:0:1::/64.
MAC addresses are notated like 0:1a:2b:3c:4d:5e.
.Pp