Remove newline from log message.

[tinc] / README

diff --git a/README b/README
index 243f0ef..ed1d2b4 100644 (file)
--- a/README
+++ b/README
@@ -1,10 +1,10 @@
-This is the README file for tinc version 1.0.2. Installation
+This is the README file for tinc version 1.0.18. Installation
 instructions may be found in the INSTALL file.
 
-tinc is Copyright (C) 1998-2003 by:
+tinc is Copyright (C) 1998-2012 by:
 
-Ivo Timmermans <ivo@o2w.nl>,
-Guus Sliepen <guus@sliepen.eu.org>,
+Ivo Timmermans,
+Guus Sliepen <guus@tinc-vpn.org>,
 and others.
 
 For a complete list of authors see the AUTHORS file.
@@ -55,8 +55,8 @@ should be changed into "Device", and "Device" should be changed into
 Compatibility
 -------------
 
-Version 1.0.2 is compatible with 1.0.1, 1.0 and 1.0pre8 but not with older versions
-of tinc.
+Version 1.0.18 is compatible with 1.0pre8, 1.0 and later, but not with older
+versions of tinc.
 
 
 Requirements
@@ -69,14 +69,12 @@ this library is not installed on you system, configure will fail.  The
 manual in doc/tinc.texi contains more detailed information on how to
 install this library.
 
-Since 1.0pre6, the zlib library is used for optional compression. You need this
-library whether or not you plan to enable the compression. You can find it at
-http://www.gzip.org/zlib/. Because of a possible exploit in earlier versions we
-recommand that you download version 1.1.4 or later.
+Since 1.0pre6, the zlib library is used for optional compression. You can
+find it at http://www.gzip.org/zlib/. Because of a possible exploit in
+earlier versions we recommend that you download version 1.1.4 or later.
 
-Since 1.0, the lzo library is also used for optional compression. You need this
-library whether or not you plan to enable compression. You can find it at
-http://www.oberhumer.com/opensource/lzo/.
+Since 1.0, the lzo library is also used for optional compression. You can
+find it at http://www.oberhumer.com/opensource/lzo/.
 
 In order to compile tinc, you will need a GNU C compiler environment.
 
@@ -115,8 +113,7 @@ Support for routing IPv6 packets has been added. Just add Subnet lines with
 IPv6 addresses (without using :: abbreviations) and use ifconfig or ip (from
 the iproute package) to give the virtual network interface corresponding IPv6
 addresses. tinc does not provide autoconfiguration for IPv6 hosts, if you need
-it use radvd or zebra. Tunneling IPv6 packets only works on Linux, FreeBSD,
-Windows and possibly OpenBSD.
+it use radvd or zebra.
 
 It is also possible to make tunnels to other tinc daemons over IPv6 networks,
 if the operating system supports IPv6.  tinc will automatically use both IPv6