Change AutoConnect from int to bool.

[tinc] / doc / tinc.conf.5.in

diff --git a/doc/tinc.conf.5.in b/doc/tinc.conf.5.in
index 28296fb..072bf07 100644 (file)
--- a/doc/tinc.conf.5.in
+++ b/doc/tinc.conf.5.in
@@ -114,15 +114,13 @@ If
 .Qq any
 is selected, then depending on the operating system both IPv4 and IPv6 or just
 IPv6 listening sockets will be created.
 .Qq any
 is selected, then depending on the operating system both IPv4 and IPv6 or just
 IPv6 listening sockets will be created.

-.It Va AutoConnect Li = Ar count Po 0 Pc Bq experimental
-If set to a non-zero value,
+.It Va AutoConnect Li = yes | no Po no Pc Bq experimental
+If set to yes,

 .Nm
 .Nm

-will try to only have
-.Ar count
-meta connections to other nodes,
-by automatically making or breaking connections to known nodes.
-Higher values increase redundancy but also increase meta data overhead.
-When using this option, a good value is 3.
+will automatically set up meta connections to other nodes,
+without requiring
+.Va ConnectTo
+variables.

 .It Va BindToAddress Li = Ar address Op Ar port
 This is the same as
 .Va ListenAddress ,
 .It Va BindToAddress Li = Ar address Op Ar port
 This is the same as
 .Va ListenAddress ,


@@ -169,7 +167,9 @@ The names should be known to this tinc daemon
 line).
 .Pp
 If you don't specify a host with
 line).
 .Pp
 If you don't specify a host with

-.Va ConnectTo ,
+.Va ConnectTo
+and don't enable
+.Va AutoConnect ,

 .Nm tinc
 won't try to connect to other daemons at all,
 and will instead just listen for incoming connections.
 .Nm tinc
 won't try to connect to other daemons at all,
 and will instead just listen for incoming connections.