Explicitly mention that LibreSSL can be used as well.

[tinc] / doc / tinc.conf.5.in

diff --git a/doc/tinc.conf.5.in b/doc/tinc.conf.5.in
index 4fc70cf..ead3d29 100644 (file)
--- a/doc/tinc.conf.5.in
+++ b/doc/tinc.conf.5.in
@@ -1,4 +1,4 @@
-.Dd 2014-01-29
+.Dd 2016-04-11
 .Dt TINC.CONF 5
 .\" Manual page created by:
 .\" Ivo Timmermans
@@ -266,6 +266,10 @@ Tinc will expect packets read from the virtual network device
 to start with a four byte header containing the address family,
 followed by an IP header.
 This mode should support both IPv4 and IPv6 packets.
+.It utun Pq OS X
+Set type to utun.
+This is only supported on OS X version 10.6.8 and higher, but doesn't require the tuntaposx module.
+This mode should support both IPv4 and IPv6 packets.
 .It tap Pq BSD and Linux
 Set type to tap.
 Tinc will expect packets read from the virtual network device
@@ -545,7 +549,7 @@ variables can be specified, in which case each address will be tried until a wor
 connection has been established.
 .It Va Cipher Li = Ar cipher Pq blowfish
 The symmetric cipher algorithm used to encrypt UDP packets.
-Any cipher supported by OpenSSL is recognised.
+Any cipher supported by LibreSSL or OpenSSL is recognised.
 Furthermore, specifying
 .Qq none
 will turn off packet encryption.
@@ -562,7 +566,7 @@ Possible values are 0 (off), 1 (fast zlib) and any integer up to 9 (best zlib),
 10 (fast lzo) and 11 (best lzo).
 .It Va Digest Li = Ar digest Pq sha1
 The digest algorithm used to authenticate UDP packets.
-Any digest supported by OpenSSL is recognised.
+Any digest supported by LibreSSL or OpenSSL is recognised.
 Furthermore, specifying
 .Qq none
 will turn off packet authentication.