Fix typo.

[tinc] / doc / tinc.texi

diff --git a/doc/tinc.texi b/doc/tinc.texi
index 091b5e7..a938c27 100644 (file)
--- a/doc/tinc.texi
+++ b/doc/tinc.texi
@@ -818,6 +818,13 @@ Tinc will expect packets read from the virtual network device
 to start with an Ethernet header.
 @end table
 
 to start with an Ethernet header.
 @end table
 

+@cindex DirectOnly
+@item DirectOnly = <yes|no> (no)
+When this option is enabled, packets that cannot be sent directly to the destination node,
+but which would have to be forwarded by an intermediate node, are dropped instead.
+When combined with the IndirectData option,
+packets for nodes for which we do not have a meta connection with are also dropped.
+

 @cindex Forwarding
 @item Forwarding = <off|internal|kernel> (internal)
 This option selects the way indirect packets are forwarded.
 @cindex Forwarding
 @item Forwarding = <off|internal|kernel> (internal)
 This option selects the way indirect packets are forwarded.


@@ -1341,7 +1348,7 @@ Address = 1.2.3.4
 
 Note that the IP addresses of eth0 and tap0 are the same.
 This is quite possible, if you make sure that the netmasks of the interfaces are different.
 
 Note that the IP addresses of eth0 and tap0 are the same.
 This is quite possible, if you make sure that the netmasks of the interfaces are different.

-It is in fact recommended to give give both real internal network interfaces and tap interfaces the same IP address,
+It is in fact recommended to give both real internal network interfaces and tap interfaces the same IP address,

 since that will make things a lot easier to remember and set up.
 
 
 since that will make things a lot easier to remember and set up.
 
 


@@ -1364,8 +1371,8 @@ ConnectTo = BranchA
 @end example
 
 Note here that the internal address (on eth0) doesn't have to be the
 @end example
 
 Note here that the internal address (on eth0) doesn't have to be the

-same as on the tap0 device.  Also, ConnectTo is given so that no-one can
-connect to this node.
+same as on the tap0 device.  Also, ConnectTo is given so that this node will
+always try to connect to BranchA.

 
 On all hosts, in @file{@value{sysconfdir}/tinc/company/hosts/BranchB}:
 
 
 On all hosts, in @file{@value{sysconfdir}/tinc/company/hosts/BranchB}: