Remove GraphDumpFile from the manual and manpages.

This option is not supported in tinc 1.1, "tincctl dump graph" can be used
instead.

diff --git a/doc/tinc.conf.5.in b/doc/tinc.conf.5.in
index ba753f4..350a410 100644 (file)
--- a/doc/tinc.conf.5.in
+++ b/doc/tinc.conf.5.in
@@ -297,18 +297,6 @@ Incoming packets are always sent to the TUN/TAP device, even if the packets are
 This is less efficient, but allows the kernel to apply its routing and firewall rules on them,
 and can also help debugging.
 .El
-.It Va GraphDumpFile Li = Ar filename
-If this option is present,
-.Nm tinc
-will dump the current network graph to the file
-.Ar filename
-every minute, unless there were no changes to the graph.
-The file is in a format that can be read by graphviz tools.
-If
-.Ar filename
-starts with a pipe symbol |,
-then the rest of the filename is interpreted as a shell command
-that is executed, the graph is then sent to stdin.
 .It Va Hostnames Li = yes | no Pq no
 This option selects whether IP addresses (both real and on the VPN) should
 be resolved. Since DNS lookups are blocking, it might affect tinc's

diff --git a/doc/tinc.texi b/doc/tinc.texi
index d4c527f..0e2b1eb 100644 (file)
--- a/doc/tinc.texi
+++ b/doc/tinc.texi
@@ -1027,16 +1027,6 @@ This is less efficient, but allows the kernel to apply its routing and firewall
 and can also help debugging.
 @end table
 
-@cindex GraphDumpFile
-@item GraphDumpFile = <@var{filename}>
-If this option is present,
-tinc will dump the current network graph to the file @var{filename}
-every minute, unless there were no changes to the graph.
-The file is in a format that can be read by graphviz tools.
-If @var{filename} starts with a pipe symbol |,
-then the rest of the filename is interpreted as a shell command
-that is executed, the graph is then sent to stdin.
-
 @cindex Hostnames
 @item Hostnames = <yes|no> (no)
 This option selects whether IP addresses (both real and on the VPN)